Boat Pole or Hook Cradle/Holder

This pair of hardwearing, UV stable, robust and rust free boat hook and pole cradles are an ideal alternative to the typical metal variety found on most narrowboats and widebeams

Simply drill and tap two M6 holes into your roof and use the supplied stainless hardware (with a little sealant and/or PTFE tape around the thread) and tighten each one down (one fixing per cradle)

One pair is enough to do one hook or one pole

If like me you find the typical pole/hook/gang plank rack bulky and difficult to paint/maintain, not to mention that they put the pole and hook in the wrong location, then try these. You can then position a pair at the stern to house you hook and a pair at the bow for the pole, where they should be!

They also have the advantage of being low profile in comparison so look less intrusive/obvious

Designed to comfortably take standard diameter hooks and poles up to 50mm

Printed from UV stable, high temperature, weather resistant PETG in black

Pack quantity

2 cradles with M6 fixing hardware