Mobile Lighting Tower Instructions

Kit Contents

A - Main body (two halves)

B - Trailer towing arm

C - Wheels

D - Towing arm stabaliser

E - Rear stabilisers

F - Base of lighting tower

G - Second stage of lighting tower

H - Third stage of lighting tower

I - Lighting tower head

Build Instructions

1. Take the two body halves (A), apply glue to one surface and press together taking care to align the two parts

2. Take the lighting tower base (F) and remove any excess from the pin that will locate into the body

3. Decide on the required height of the lighting tower and carefully cut the two extension pieces (G) and (H) down to length if needed, such that 3 to 5mm is left to slide into the receiving sections

4. Glue the three grey lighting sections together

5. Now the body, lighting tower and towing arm (B) can be painted to your desired colours

6. Take the lighting head (I) and drop glue into the centre recess and stick to the top of the completed lighting tower, making sure it is all square

7. Apply glue to the two small towing arm slots on the body and slide in the towing arm (B)

8. Apply glue to the two axle holes on the body and position the wheels (C), making sure the sit nicely within the mud guards

9. Decide if the trailing is being towed or set down, the rear stabilisers (E) are not symmetrical so can be position in the up or down position. To fit in place apply a drop of glue to the holes and slide the stabilisers into position, leaving them extended or fully pushed home as required

10. Fit the front stabiliser bar (D) by applying a drop of glue to the towing arm and position, the bar is over sized to ease handling and thus should be trimmed to a realistic height when dry

11. Finally fit the lighting tower to the body by applying some glue to the receiving hole in the body and push in the lighting tower

SKU: MAC02